Thread: Removing the choke plates?
04-15-2007, 08:27 AM #1
Removing the choke plates?
I am doing some work on my 1390 GK , and I have removed the Choke plates, Linkage, and rods. Now what Do I put in the holes? Can I use epoxy puddy?Or Is there a SMARTER thing that is made, or can be made for that?
Will I have to rejet now? I was at 1.5 on highs and 3/4 on lows. any thoughts on this would be helpful, thanks
04-15-2007, 10:33 AM #2
I bought brass plugs from Carl at Island they were cheap they press in the plastic sleeve in the hole. I use a little loctite when I install them.
04-15-2007, 10:35 AM #3
Are you installing a primer fittings? Or just trying to elimnate the restriction.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Bamaha1 in forum Yamaha PWC Performance (4-stroke)Replies: 1Last Post: 07-11-2013, 07:00 PM
By Sayre in forum Yamaha PWC Performance (2-stroke)Replies: 11Last Post: 05-10-2012, 07:49 PM
By 153stars in forum Polaris Open DiscussionReplies: 4Last Post: 08-09-2011, 09:43 PM
By turk0004 in forum Polaris Open DiscussionReplies: 3Last Post: 08-16-2009, 08:51 PM
By yellow4 in forum 4-Tec PerformanceReplies: 7Last Post: 07-19-2007, 10:51 PM