Results 1 to 2 of 2
  1. #1
    SLAP~YA's Avatar
    Join Date
    May 2013
    Sunshine Coast, QLD

    SHO Turbo question

    Just wanting to know form any one who has done a turbo conversion on an SHO

    The oil pump has a small piece the slots in to the block to feed oil to the supercharger idler shaft does that get blanked off once the clutch assay has been removed?

    Also the chrome steel pipe that runs from the side of the engine block around to the front of the oil pump does that stay or can it be blanked off on the oil pump and the outlet from the block used to feed the turbo.


  2. #2

    Join Date
    Nov 2014
    ballina nsw
    tap another fitting into the front of the pump so u can run as a drain, then run a t piece at the oil sensor for a feed if its a front mount turbo

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FX SHO Mod Questions
    By blaster3500 in forum Yamaha PWC Performance (4-stroke)
    Replies: 5
    Last Post: 07-09-2008, 08:49 PM
  2. Turbo Question, .48a/r or .63a/r
    By Hecyan in forum 4-Tec Performance
    Replies: 11
    Last Post: 06-19-2008, 08:43 PM
  3. RXP Turbo Question
    By Brad Clarke in forum 4-Tec Performance
    Replies: 22
    Last Post: 04-17-2008, 12:36 PM
  4. SHO intake questions....
    By jtskier11 in forum Yamaha PWC Performance (4-stroke)
    Replies: 0
    Last Post: 11-09-2007, 08:27 AM
  5. MSX 150 turbo question
    By Cobralyn in forum Polaris Open Discussion
    Replies: 5
    Last Post: 09-30-2006, 05:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts