Thread: Riva Pump Extension RXP / RXPX
04-13-2015, 06:15 AM #1
Riva Pump Extension RXP / RXPX
Well not too many of these around as RIVA stopped making them because of high cost +$1000. All original parts included. Fits RXP and RXPX ( non T3 hull ). SS Wear ring in good condition only typical surface abrasion, no deep gouges, ID is 159.0 mm. In fact the wear ring can be flipped so you would have factory finish on impeller end. I checked with caliper and can not measure wear. Price is $325 and does not include shipping. If no takers here I will list on ebay. SOLD
Last edited by PWCGUY; 04-26-2015 at 08:15 AM.
04-13-2015, 05:58 PM #2
Just to clarify a bit ... Slow91 reminded me that RIVA had some drive shaft issues with this kit which is true for the first run of units they sold but this was bought later on and its been run for a few seasons with no issues. I just took it off last season as I got a Flyboard and wanted to swap between two different pumps with two different impellers. It will significantly improve hook-up in rough water for RXP and adds 1 -2 mph for RXP-X.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By BigDaddyRXP in forum Sea Doo ClassifiedsReplies: 7Last Post: 02-17-2013, 01:32 PM
By blackvr in forum Sea Doo ClassifiedsReplies: 3Last Post: 09-25-2011, 04:26 PM
By b_dolla44 in forum Sea Doo ClassifiedsReplies: 15Last Post: 11-24-2010, 09:39 AM
By INDY27 in forum 4-Tec PerformanceReplies: 2Last Post: 11-23-2008, 07:50 PM
By rx4pain in forum 4-Tec PerformanceReplies: 36Last Post: 07-21-2008, 05:22 PM