Thread: stinger3 question??
04-16-2007, 02:22 PM #1
alright, the 3/8 tube that comes off the t fitting opposite the water restrictor.. riva says run a pisser out the back. ive seen the temp sensor taken out and the line feeds the water box.. which one should i do??
04-17-2007, 07:43 PM #2
If you are gonna kept the water restrictor that comes with it, run it out a pisser. The way it works is that the water exits out the "T" fitting, and you adjust how much you want to inject back into the pipe.
What I've done with mine is to replace the T fitting with a 90 degree fitting, and dumping all the water from the pipe proir to the Stinger out the pissers. Then I piped in water from the pump through a jetworks valve; the pipe stays dry under 3000 RPM like the standard Jetworks mod. I kept the restrictor inline to adjust how much water I want going in the top side.
04-18-2007, 04:30 PM #3
sweet thats all i needed to hear.....i just didnt know if runnin a pisser would make the box to dry..
so if im doin WOT, long trips i wanna keep the box wetter not dryer right??
IE: restrictor opened
04-18-2007, 04:33 PM #4
Remy, you dont want the box to be dry for a long period of time, and you definately dont want it dry at anything over 3500 RPM.
04-18-2007, 04:52 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MPower in forum 4-Tec PerformanceReplies: 5Last Post: 08-11-2009, 10:04 AM
By rx4pain in forum 4-Tec PerformanceReplies: 34Last Post: 11-21-2008, 10:36 PM
By rxp_boy in forum 4-Tec PerformanceReplies: 4Last Post: 05-23-2005, 10:03 AM
By Therock in forum 4-Tec PerformanceReplies: 3Last Post: 05-20-2005, 07:13 AM
By 1FastTrespiper in forum 4-Tec PerformanceReplies: 4Last Post: 05-08-2005, 10:53 PM