I am new to the forum and have read a lot of good info on here. Now decided to add my problem and see if you guys can help me. I just rebuilt my 1300 ,added new crankshaft and Pistons. When I went to start the motor I get no fuel to the cylinders. I have spark to all three. I had to install a fuel pump and new injectors. I did check the voltage on the injectors they are around 10.0 v. The battery while cranking is 11.0v. All connectors are connected and no loose or damaged wires. No trouble codes. It has the D plate added also with the chip. I hooked up my battery charger and raised the voltage and it still wouldn't start. Is there anything else that I need to check from here. Any suggestions would be appreciated.