Thread: Igni-Power ignition for race
04-23-2015, 01:10 PM #1
Igni-Power ignition for race
guys I want to ask you, someone use igni power full programmable race ignition in your closed course race seadoo's?
04-23-2015, 01:45 PM #2
04-23-2015, 02:51 PM #3
I bought igni power and I want to know, maybe who's have good map for 9200rpm and Et68-140 xle scer.
04-23-2015, 03:20 PM #4
04-23-2015, 03:27 PM #5
I believe there was a section in the forum for Igni-Power a long time ago where members shared maps. Maybe a moderator or admin will chime in about that.
04-23-2015, 03:56 PM #6
Thanks for help guys, I sent message to Malte but he still don't answer for me.
Last edited by kimi; 06-14-2015 at 02:46 PM.
06-14-2015, 02:46 PM #7
Hi, I want to ask guys maybe who know how I can to connect Lambda Sensor on igni power ECU? I want to correct my air/fuel ratio on my map.
06-14-2015, 03:14 PM #8
You can not connect Lambda ...but you have EGT sensor (3 one per cyl)...to get a good tune you have to keep them work between 750 and 850 celcius degrees and check you dont have flashs on the leds for knock.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By iron head in forum 4-Tec PerformanceReplies: 4Last Post: 03-27-2011, 08:04 PM
By Richieb in forum Sea Doo ClassifiedsReplies: 4Last Post: 06-09-2010, 06:54 AM
By AEVJEEP in forum Kawasaki PWC Performance (2-stroke)Replies: 1Last Post: 12-28-2008, 11:35 AM
By grantuk in forum Sea Doo ClassifiedsReplies: 2Last Post: 09-24-2008, 10:50 AM
By NOTAM in forum 4-Tec PerformanceReplies: 7Last Post: 04-03-2008, 12:38 AM