Thread: Re-fitting drive shaft C-clip.
04-28-2015, 08:02 AM #1
Re-fitting drive shaft C-clip.
Hey guys, I've fitted new pto bearing and bellows and top hat (collar) In my 2004 GTX. Now I'm trying to pull back the collar to fit the C-clip but having no luck! I can pull it back a few mm maby quarter of an inch but I just can't get it back enough to even see where the C-clip goes. Any ideas, tricks and tips in doing this? Thanks jamie
04-28-2015, 08:06 AM #2
04-28-2015, 08:23 AM #3
Use the correct tools, like these two and it is so easy.
Last edited by jpt7779; 04-28-2015 at 09:04 AM.
04-28-2015, 08:23 AM #4
04-28-2015, 10:36 AM #5
I throw a socket in the prop and loosly put the pump back on. This pushes the driveshaft forward slightly so you are not fighting it wanting to move back. Don't tighten the bolts though, you don't want to push the shaft too far forward. I have never had a problem with not having the tool doing this.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RXP-TOM in forum Sea Doo ClassifiedsReplies: 7Last Post: 10-12-2010, 09:39 PM
By 2 Strokin' Polaris in forum Polaris Open DiscussionReplies: 8Last Post: 09-03-2010, 05:51 PM
By R88ory RXP in forum 4-Tec PerformanceReplies: 27Last Post: 12-16-2009, 02:56 AM
By need4pwr in forum Yamaha ClassifiedsReplies: 8Last Post: 07-31-2008, 11:56 AM
By GarageDetailer in forum 2-Stroke PerformanceReplies: 5Last Post: 06-10-2008, 08:58 PM