Results 1 to 2 of 2
  1. #1
    Mpeavler's Avatar
    Join Date
    Dec 2005
    Location
    Anderson, Indiana
    Posts
    5,155
    +1
    170

    BRP install instructions for Depth Finder T3 Hull

    Anyone have these laying around or can scan a copy of them for me. I'm curious as I purchased 2 new depth finders for my RXP-X and RXT-X. I had the dealer install them so I could get the longer warranty on them "4 year" vs 90 days if I did this. Well the RXP-X works but it's kinda intermittent more then I figured it would be. I looked inside and from I recall the unit should be almost level with the horizon when you place the mount in with the angle matching the hull but tilting the unit more vertical and mine is just the opposite... and almost lay's towards the drive shaft area.

    This one works...and maybe it was because I was turning some before it reports goofy. I guess I'm just wondering if the mechanic installed the mount the wrong way and I can't find any instructions like the ones I seen with it in the box. I know the hull is at an angle... is it possible the unit is glued in backwards?


    My RXT-X one does not read at all and I have to take it back to them. It just shows the ------ marks. It powers on but zero readings and I know this one goes under the battery and snaps in so it must be bad or rigged wrong or a gap.

    M
    Last edited by Mpeavler; 05-05-2015 at 12:28 PM.


  2. #2
    Mpeavler's Avatar
    Join Date
    Dec 2005
    Location
    Anderson, Indiana
    Posts
    5,155
    +1
    170
    Quick shout out to Ryan for finding the issue and fixing it on my rxt. The gap was to much for a gel pad so he just 3m'd it In and now it reads.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Installation instructions for Farthing sponsons?
    By mrstaffo in forum Yamaha PWC Performance (4-stroke)
    Replies: 0
    Last Post: 03-19-2013, 01:05 PM
  2. Installation instructions for evolution marine trim tabs on a 785
    By racer447 in forum Polaris PWC Performance
    Replies: 2
    Last Post: 06-09-2010, 12:25 PM
  3. Install Instructions for IR Vapor Seperator
    By smacota1 in forum Yamaha How To & FAQs
    Replies: 4
    Last Post: 04-30-2010, 02:23 PM
  4. harness for depth finder
    By RXP Blur in forum 4-Tec Performance
    Replies: 2
    Last Post: 09-29-2007, 12:33 PM
  5. Wireing a RXP for depth finder
    By RXP Blur in forum 4-Tec Performance
    Replies: 2
    Last Post: 05-14-2007, 06:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •