Thread: Rxt x
05-09-2015, 05:41 PM #1
- Join Date
- May 2015
Hi, I just picked up a 2015 rxt x 260 and put 5 hr on it and still only goes 24 mph and 45 or so with the learning key. The book says after 5 hr u will be ok. Any ideas? Thanks
05-09-2015, 06:05 PM #2
Dont use the learner key!
Last edited by troyheb; 05-09-2015 at 07:46 PM.
05-09-2015, 08:38 PM #3
No where in your Owners Manual regarding break in does it say to use the Learning key! READ YOUR MANUAL!
This is NOT how to get the piston rings set.
05-11-2015, 10:00 PM #4
I have a RXT X, do not use your lerner key to break in a new engine, it is the worst thing you can do! You need to break your engine with different RPM ranges so the rings will set properly. If you have 5 hrs start using your man key and ride with low, middle and high RPM's, after another hour or two kick in sport mode and ride in that RPM range. After 10hrs get it back to your dealer for oil change, spark plugs and have them check for loose hoses and anything else that can fail.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MPower in forum 4-Tec PerformanceReplies: 5Last Post: 08-11-2009, 10:04 AM
By hdsilverado in forum Sea Doo Open DiscussionReplies: 3Last Post: 04-06-2008, 09:18 AM
By Shibby1485 in forum 4-Tec PerformanceReplies: 18Last Post: 05-22-2005, 07:22 PM
By jonstephens in forum 4-Tec PerformanceReplies: 7Last Post: 05-17-2005, 05:14 PM
By diceclay in forum Sea Doo Open DiscussionReplies: 4Last Post: 05-02-2005, 02:24 PM