05-14-2015, 02:19 PM #1
Anyone running Tial 50 mm BOV with Riva Gen-2 power cooler?
As the tittle says i want to get rid of the HKS SSQ BOV and go with the Tial 50 mm. I have the Riva Gen-2 power cooler so i have to weld the Tial bracket to the IC tube. Anyone with pics of this setup??
05-14-2015, 02:33 PM #2
05-14-2015, 04:38 PM #3
- Join Date
- Mar 2014
- Siesta Key, Fl
The issue with the adapters is the hole is smaller for the HKS over the Tial to you will not get the max benefit of the Tial.
By putting the flange on the IC pipe you will have the proper size hole and get much better flow out the BOV
05-14-2015, 05:48 PM #4
Edit - Forgot your Riva elbow has a much tighter radius then my setup. Prob your best bet is to pick up a full flow/bore adapter & weld it up to the original (opened up) BOV location. Elbow would work too, just go with your preference..
Last edited by WP3223; 05-14-2015 at 11:27 PM.
05-15-2015, 03:16 AM #5
05-15-2015, 03:24 AM #6
05-15-2015, 08:04 AM #7
Steve I like that. Nice work!
05-15-2015, 08:55 AM #8
Thanks you all guys for the replies, my idea was to weld the flange to the elbow but now i prefer your setup steved so i dont have to modify the ic piping. I will go that route!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By r33pwrd in forum Yamaha Open DiscussionReplies: 4Last Post: 06-23-2013, 03:45 PM
By alex29573 in forum 4-Tec PerformanceReplies: 17Last Post: 03-28-2013, 07:57 PM
By BAYOU FZR in forum Sea Doo ClassifiedsReplies: 8Last Post: 09-02-2010, 11:36 AM
By Water4fire in forum 4-Tec PerformanceReplies: 23Last Post: 11-23-2008, 08:39 PM
By Seadooracer9 in forum 4-Tec PerformanceReplies: 9Last Post: 05-22-2008, 04:41 PM