05-14-2015, 08:23 PM #1
Making a hitch reciever jig to re-pitch my prop and I have a couple questions.
#1 I don't have the prop out right now, does anyone know the height of a stock 2011 FZS SHO prop?
I need to get a bolt to hold it down to the jig I'm making. A 3/4" bolt, if I remember right?
#2 Will my prop-shaft holding tool from my 2004 FXHO work for my 2011 FZS SHO?
#3 When doing prop adjustments I figure I will have the prop in and out several times. Is it okay not to
use sealer on the pump when putting it back together each time?
05-14-2015, 08:49 PM #2
Your 2004 shaft holding tool will not work as the 1.8l uses a thicker shaft.
using no sealant is fine when constantly removing the pump to change prop pitch.
once dialed in then seal it all up properly.
05-14-2015, 09:00 PM #3
05-15-2015, 11:50 AM #4
Here's how I set mine up. Make sure to use a big-ass wrench to do it. I bought a 22" crescent wrench from Harbor Fright for like 20$
Also read this thread: http://www.greenhulk.net/forums/showthread.php?t=20995
05-15-2015, 02:30 PM #5
I'm ready to go, I have a 1/2" thick 12" round plate, receiver, 24" crescent wrench and the gauge. I was hoping to get the bolt before I go to the lake but the prop is on the ski at the lake. I was thinking an 8" bolt but the stock prop is pretty tall so I'm not sure 8" is long enough. Anyone have a stock prop they can measure for me?
05-16-2015, 06:40 PM #6
05-16-2015, 07:18 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mstennes in forum 4-Tec PerformanceReplies: 9Last Post: 08-11-2009, 09:26 PM
By SHOBiz in forum Yamaha ClassifiedsReplies: 6Last Post: 07-08-2009, 07:44 PM
By Gus13letter in forum 4-Tec PerformanceReplies: 53Last Post: 12-26-2008, 10:16 AM
By camar0 in forum 4-Tec PerformanceReplies: 8Last Post: 09-16-2008, 12:50 PM
By syk1300 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 04-08-2008, 02:16 PM