Thread: What am I missing?
04-22-2007, 11:57 AM #1
What am I missing?
I am trying to remove the prop housing so I can replace my wear ring when it comes next week.
I can't seem to get the pump off without taking the driveshaft with it. The pump and prop housing will come out about 4", but that's it. Do I need to remove the couplers and pull the entire thing out as one or am I missing something?
Here's a pic of where I am at:
04-22-2007, 01:06 PM #2
the pump and shaft should all come out/slide out as one.
when you are pulling it out, make sure the top of the stator section is not catching on the trim cable.
I can feel like that it is stuck if the trim cable is hanging over the top of the pump like it is.
Last edited by RX951; 04-22-2007 at 02:09 PM.
04-22-2007, 02:08 PM #3
Got it. I guess I was being too nice. I noticed one of the pump vanes has a knick in it. I'll post pics a little later.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Sundance in forum 4-Tec PerformanceReplies: 4Last Post: 06-05-2008, 10:05 PM
By seaobin in forum Polaris Open DiscussionReplies: 22Last Post: 12-06-2007, 09:43 PM
By kkgregs in forum Sea Doo Open DiscussionReplies: 6Last Post: 04-24-2007, 11:34 PM
By porksword in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 03-08-2007, 11:20 AM
By WAMason in forum Sea Doo Open DiscussionReplies: 1Last Post: 06-30-2006, 08:05 PM