Thread: Hot Seat 785 Head modifications
04-25-2007, 11:38 AM #1
Hot Seat 785 Head modifications
Alright so I think I want to do the cooling mod to the Hot Seat head kit that I have.
I have some reservations about drilling into the shiny new piece, but I think its for the better.
The top piece that I will be drilling into not very thick. Is it okay if the 90 degree elbows to thread in past the bottom surface of the top piece? How far should I look to screw them in?
Anything else I need to know to do this properly on the 785 head?? I would hate to screw it up.
04-25-2007, 12:32 PM #2
- Join Date
- Jan 2007
Get an ADA head? Just kidding. I have or have had Pro 785 race machines with both heads. I like the cooling idea of the ADA head with each cylinder having a cooling line. However, I've had three limitesds and one suuperstock with the Hot Seat heads where I just ran the one cooling hose out of the back of the ski (where the bilge pump exit is or drilled an additional hole) and I never had any cooling problems.
04-25-2007, 01:15 PM #3
Any experience drilling and taping the Hot Seat head to set it up like the ADA??
I guess that's what I am looking to do here. I don't have a problem going with the single outlet on the Hot Seat head, but If I can get it set up to run three cooling lines reliably I would like to do it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
WTB - Parts Hot seat 785 headBy Kerminator in forum Polaris ClassifiedsReplies: 6Last Post: 07-31-2013, 10:30 PM
By 785 lugs in forum Polaris ClassifiedsReplies: 5Last Post: 11-10-2009, 11:55 PM
By 785 lugs in forum Polaris ClassifiedsReplies: 6Last Post: 06-29-2009, 11:09 AM
By Screamin'SLX in forum Polaris ClassifiedsReplies: 2Last Post: 01-13-2009, 09:42 PM
By Screamin'SLX in forum Polaris ClassifiedsReplies: 7Last Post: 11-12-2008, 08:15 PM