04-25-2007, 05:22 PM #1
need Part # for RXP driveshaft holding tool
stumbled accross it once in the manual but cant find it now..
theres a splined tool that
1) removing pump.
2) slide this spined inside - hex outside tool on the driveshaft to turn it.
anybody got a clue
04-25-2007, 06:33 PM #2
04-25-2007, 08:02 PM #3
Daniel i know what tool you are talking about... i used it just last weekend when i put my new camshaft in to make sure everything was timed ok and nothing was binding or interfering..
nice tool to have!
i'll see if i can get the part # for you
04-25-2007, 09:55 PM #4
if you're just wanting to turn the driveshaft I'll tell you how I did it. I had a pump shaft from an old 951 pump, put my stock prop on that pump shaft and snugged it down, put this on the driveshaft and used an open end wrench to turn the pump shaft. worked fine and cost zero $'s..
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tommysaxboy in forum TigersharkReplies: 0Last Post: 07-10-2011, 03:06 PM
By BOUDHA in forum Conversion PWC Performance SkisReplies: 6Last Post: 12-14-2007, 04:11 AM
By tburn in forum Polaris PWC PerformanceReplies: 2Last Post: 07-10-2007, 08:35 PM
By f150vtx in forum Polaris Open DiscussionReplies: 6Last Post: 05-07-2007, 08:57 PM
By TorquePhoto in forum 4-Tec PerformanceReplies: 2Last Post: 07-26-2006, 09:57 PM