12-14-2005, 07:11 PM #1
Is an R&D Hydroforce nozzle worth it?
Will my 96xp benefit from an r&d hydroforce nozzle. It is the seadoo 85mm. Could it possibley slow it down with a stock motor? I know it gives better turning and manueverabilty, but is it worth it at all?
12-14-2005, 10:30 PM #2
12-14-2005, 11:52 PM #3
I used one back in my race days, they looked cool and every XP800 had one. I think the interchangeable rings was a good thing to have. You could "tune" your holeshots/top-end speed with the rings. I liked the R&D trim tabs too..they helped keep the hull planted on the race course.
If you get it, start with the OEM i.d. for the nozzle. Just my opinion.
12-15-2005, 04:43 PM #4
skip it and buy you a r&d nozzle setup with the 85/88 setup. Then get you an XO prop. Thats your pump/prop combo that works best for the 96xp's.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By yamahamiamiski in forum Yamaha ClassifiedsReplies: 1Last Post: 04-08-2013, 08:47 PM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 08-03-2010, 07:25 AM
By EGGonz in forum Kawasaki PWC Performance (4-stroke)Replies: 14Last Post: 06-19-2008, 03:33 PM
By cdalesch in forum 4-Tec PerformanceReplies: 8Last Post: 06-05-2008, 08:09 PM
By Green Hornet in forum 4-Tec PerformanceReplies: 13Last Post: 06-01-2006, 07:48 PM