Thread: Umi Finger Throttle
04-29-2007, 08:48 PM #1
Umi Finger Throttle
I recently installed some UMI bars w/finger throttle on the factory steering system. I can' seem to get it to WOT before it hits the handlebar grip. At full realese it just sits on the idle stop but at WOT I'm bout 1/4in. away from the full throttle stop.
04-29-2007, 08:54 PM #2
Did you try adjusting the cable? I put the angle throttle on my first RXP and remember having to dremel a bit on the back of the throttle lever so that i could get full range of motion.
04-29-2007, 09:12 PM #3
04-29-2007, 09:33 PM #4
Hey whats up with the angled vs straight finger throttles?
04-29-2007, 09:34 PM #5
I personally prefer straight. The are straight with the bars. The angled angles down a bit.
04-30-2007, 06:11 AM #6
- Join Date
- Aug 2006
- Gonzales, La
j2, can you post a pic of your setup? I'm interested in dirtbike bars and a finger throttle, but not willing to spend $700 on the whole UMI system.
04-30-2007, 11:12 AM #7
Yes I adjusted both at the throttlebody n the finger throttle. It's adjusted right but I can't seem to get the full range of motion outta the throttle. I don't wanna have to trim off some aluminum but I think thats what it looks like.
04-30-2007, 11:32 AM #8
04-30-2007, 11:36 AM #9
04-30-2007, 11:41 AM #10
Sorry the pics are bad. UMI bars, VTS button housing grips n locking compound,finger throttle and adapter on a stock steering getup should be just over 2 bills. I had to cut n re solder/heatshrink the harness to keep it looking clean. The mode set button is on the right by the throttle.Add some 1/4in split flex over the heat shrink. More protection and it looks real clean.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 1FastTrespiper in forum Sea Doo How To & FAQsReplies: 10Last Post: 05-30-2011, 03:49 AM
By dav_dman in forum 4-Tec PerformanceReplies: 1Last Post: 07-19-2008, 04:06 PM
By ecpChris in forum General ClassifiedsReplies: 0Last Post: 06-27-2008, 10:26 AM
By ecpChris in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-27-2008, 09:57 AM
By ecpChris in forum Yamaha ClassifiedsReplies: 5Last Post: 06-27-2008, 07:13 AM