05-06-2007, 02:10 PM #1
Knock Sensor adapter - how to install?
I purchased this adapter so I can run the RXP ECU.... where does this connect to?
05-06-2007, 02:16 PM #2
It plugs in between the knock sensor connector and the wire harness.... kinda like an extension cord.
Knock senor connector is the bottom connector to the left of the ECU (there are 3 of them there)
05-06-2007, 02:48 PM #3
- Join Date
- Oct 2005
05-06-2007, 03:13 PM #4
All this looks like is an extension to the plug connector...
Does the new ecu make the original plug not connect?
05-06-2007, 03:21 PM #5
your wiring harness should be able to plug right in, all of the plugs are different so you can't mess up...
05-06-2007, 05:55 PM #6
- Join Date
- May 2005
- Louisville KY.
05-10-2007, 02:28 PM #7
Jerry, just to be 100% sure, this is the correct plug to add the adapter too right?
this is the bottom plug of the 3 next to the ECU...
05-10-2007, 03:59 PM #8
yes, like i have stated there is no two of the same connectors on the ski, you cant mess up.
05-10-2007, 04:05 PM #9
05-10-2007, 04:19 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By GTLaser in forum Sea Doo ClassifiedsReplies: 0Last Post: 09-22-2009, 06:02 PM
By BGslugger10 in forum 4-Tec PerformanceReplies: 9Last Post: 04-01-2009, 02:55 PM
By Green Hulk in forum Sea Doo How To & FAQsReplies: 15Last Post: 06-14-2008, 12:13 PM
By Autosport in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 02-18-2008, 05:30 PM
By jasonze in forum 4-Tec PerformanceReplies: 5Last Post: 01-05-2008, 08:51 PM