Results 1 to 4 of 4
  1. #1

    Join Date
    Jan 2007
    Location
    PCB, FL
    Posts
    69
    +1
    1

    Rinaldi (RXX) Reeds on DI?

    Has anyone here used the Rinaldi reeds for a RXX on a 951 DI motor? Just curious as to the fitment of the throttle bodies from the extra thickness of the reed cages, primarily the bracket that attaches to the pipe?
    Also is there noticible gains in bottom, mid and/or topend power and/or throttle responce?


  2. #2

    Join Date
    Apr 2007
    Location
    Lake Anna Va
    Posts
    83
    Can't help you with the Renaldi's but i am using Carbon Tech's in my RXDI (with the stock cage) Just from my experiance I don't think you will see much change with the reeds alone on a DI The L1 kit is the place to start. Thats going to give you the most noticeable performance gains. It's worked well on mine.

  3. #3

    Join Date
    Jan 2007
    Location
    PCB, FL
    Posts
    69
    +1
    1
    The reeds are going in along with my L1 kit with Solas impeller. Since I am doing them both at once I won't know what each or the other did for the boat seperately.
    Did you do your CT's after running the L1 for a while? What sort of difference did you notice with them? I was told that the RXX reeds/cages were noticeablely better on bottom/mid than even the CT's in stock cages.
    Last edited by BigKID; 05-07-2007 at 04:49 PM.

  4. #4

    Join Date
    Apr 2007
    Location
    Lake Anna Va
    Posts
    83
    Nah I did the same thing. Installed the reeds with other changes. My target was top end. It did squeak about another 1mph out of it. If the gods are with me it was topping out a bit over 66 with the nujet 13/22 but the beer gut is a bit larger this summer

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Any drawbacks to running VForce reeds on a TXi / DI ski?
    By UnityRacing in forum Polaris Open Discussion
    Replies: 30
    Last Post: 02-26-2015, 06:19 PM
  2. Has anyone tried spacing the stock reeds on the 1300?
    By jpa1300 in forum Yamaha PWC Performance (2-stroke)
    Replies: 26
    Last Post: 02-08-2008, 10:38 AM
  3. RXX hood on ebay.com
    By grantuk in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-10-2007, 02:27 PM
  4. RXX questions on rebuild possibilities
    By jgustman in forum Sea Doo Open Discussion
    Replies: 10
    Last Post: 06-24-2007, 12:15 PM
  5. Installed L1DI and RXX Reeds... not running right...
    By BigKID in forum 2-Stroke Performance
    Replies: 3
    Last Post: 05-25-2007, 08:35 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •