Thread: Splash guard install on GPR
05-10-2007, 01:11 PM #1
Splash guard install on GPR
I have a Hydroturf eva foam splashguard I would like to get installed. I have searched everywhere and I am unclear on whether they are mounted in back of the bond rail or in front ? (Jet Trim has install instructions for both)
If it is in front in-between the rail and bumper...Is any trimming needed on the bumper rails themselves ? Or does it take care of itself when tightening the bumper back down ?
Plan is to use contact cement and rivets.
05-10-2007, 05:21 PM #2
if it is the foam. throw it in the trash. they suck. get the hard rubber.
05-10-2007, 06:46 PM #3
05-10-2007, 07:09 PM #4
I think it I called it the wrong thing. I have had these on my doo's before and they held up with no problem (just like the Riva Splash Guard).
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By zrtman in forum Yamaha ClassifiedsReplies: 0Last Post: 10-30-2010, 09:11 PM
By 305coco in forum Yamaha ClassifiedsReplies: 3Last Post: 09-08-2010, 04:13 PM
By skigolfnut in forum Polaris Open DiscussionReplies: 0Last Post: 08-03-2009, 02:56 PM
By freperry in forum Yamaha PWC Performance (2-stroke)Replies: 11Last Post: 07-14-2009, 04:57 PM
By daverxp4 in forum 4-Tec PerformanceReplies: 6Last Post: 12-20-2008, 02:54 PM