Thread: Fountain on discovery?
05-10-2007, 07:56 PM #1
Fountain on discovery?
Did any one see the clip on fountain racing boats on discovery channel?
There was something interesting on it. It made the statement that was a cool thought.
It stated that they make a pad on the bottom of the V hull (the part the boat plains out on) that is set at a differant angle. to allow the boat to plain at one speed and but still cut in the chopps.
question? is it possible to do that to an exstiting hull?
Ok maybe I ate to many of those brownies?
05-10-2007, 08:23 PM #2
I am sure they have applied lots of their research and development on their GPR hulls
05-10-2007, 10:46 PM #3
Pretty much the same as the flat surfaces of the ride plate and pump shoe on the GPR, only it's part of the hull.
05-10-2007, 10:53 PM #4
05-10-2007, 11:04 PM #5
05-11-2007, 09:20 AM #6
i would think it would make your ski very sloppy.. just my .02cents.
05-12-2007, 08:40 AM #7
I guess I can't express my thoughts well in typing. This goes hand in hand with http://www.greenhulk.net/forums/showthread.php?t=16509
This was what I was trying to say. I never saw this post. I read it last night. very good billie.
05-12-2007, 09:21 AM #8
05-12-2007, 09:23 AM #9
05-12-2007, 09:24 AM #10
screw i will try it after mudbug and let every one know
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By HOSS in forum Sea Doo Open DiscussionReplies: 4Last Post: 08-19-2006, 07:38 AM
By HOSS in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-03-2006, 01:48 PM
By RX951 in forum Yamaha PWC Performance (2-stroke)Replies: 20Last Post: 06-22-2006, 09:21 PM
By Shibby1485 in forum Sea Doo Open DiscussionReplies: 19Last Post: 03-08-2006, 08:34 PM
By KEN G in forum 4-Tec PerformanceReplies: 3Last Post: 09-17-2005, 12:08 PM