05-17-2007, 03:42 PM #1
Possible to? and Who? Repair 4-tec Crankshaft
I need some work done on my crank... front #3 cylinder rod bearing beat up my crank so its kinda scored
What are my options?
a $1,277.49 crankshaft is not an option
05-17-2007, 03:48 PM #2
- Join Date
- Dec 2006
- Crest Hill, IL
05-17-2007, 04:12 PM #3
05-17-2007, 10:19 PM #4
jerry.... am i reading their price sheet correctly that it's about a 236 dollar job?.. is that all i'm needing, crankwork is unfamiliar territory to me, but i do know the whole crank is fine except that #3 journal
weld and grind the crank... think that's per journal? or the whole crank?
i'll ring them tomorrow as well
05-17-2007, 10:26 PM #5
Shibby, I have used them 3-4 times and their work was top notch!
05-17-2007, 10:31 PM #6
there a such thing as oversized bearings for these 4-tecs?
05-17-2007, 10:31 PM #7
Shib, best thing to do is call them in the morning and arrange to send it in.
Nils uses these guys too.
Oh, they also strengthen rods. I sent mine in and i believe it was only about $150 for the set. Might as well do that too while you are at it.
05-17-2007, 10:32 PM #8
05-17-2007, 10:37 PM #9
- Join Date
- Jan 2006
- Rydal, Georgia U S A
05-18-2007, 06:54 AM #10
yes there is!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By polarisjunky in forum Polaris Open DiscussionReplies: 1Last Post: 06-08-2013, 12:23 PM
By chevydog in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 05-21-2012, 07:27 AM
By rhislo in forum Sea Doo ClassifiedsReplies: 0Last Post: 09-23-2010, 03:00 PM
By superduty in forum Sea Doo Open DiscussionReplies: 28Last Post: 08-28-2007, 02:39 PM
By Water4fire in forum 4-Tec PerformanceReplies: 7Last Post: 10-28-2005, 10:16 PM