Results 1 to 5 of 5
  1. #1

    Join Date
    Aug 2017
    Location
    Northern BC Canada
    Posts
    3

    SLTX updated ignition how to tell if it's been updated?

    I just picked up a 99 SLTX 1050 not sure it has been updated by previous owner he said he had it in the shop and spent about $1200 on it and it still wouldn't run and wasn't sure what had been done other than the carbs. The CDI # 4060180 and the coil # 401074. Click image for larger version. 

Name:	IMG_1502573300.794773.jpg 
Views:	24 
Size:	144.9 KB 
ID:	418901

  2. #2
    Bdesim's Avatar
    Join Date
    Aug 2012
    Location
    Chicago
    Posts
    229
    +1
    4

    SLTX updated ignition how to tell if it's been updated?

    4060180 is a non updated cdi

    Have you checked for spark?

  3. #3

    Join Date
    Aug 2017
    Location
    Northern BC Canada
    Posts
    3
    Yes good spark full charge on battery starts but no throttle response or very little then it dies but restarts with some choke. I replaced the fuel lines and cleaned the carbs they were full of junk maybe still stuff in the system and need to clean again.

  4. #4
    Bdesim's Avatar
    Join Date
    Aug 2012
    Location
    Chicago
    Posts
    229
    +1
    4
    You have something going on with the fuel system still.

    I suggest you go through the entire fuel system again. Go back through the carbs and make sure you blow out each spot with compressed air and make sure each jet and passage is clear. (Don't forget the internal fuel filter) it maybe time for a full rebuild.

    Oh! Make sure your fuel selector switch isn't leaking air into the fuel system.

    Is the water separator full of fuel ? If not there could be a problem with the fuel pump on the carbs.

  5. #5

    Join Date
    Aug 2017
    Location
    Northern BC Canada
    Posts
    3
    Ok thanks! I'll go through everything and test it again I'm hoping it's something simple I'll let you know how I make out thanks again.


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 97 slt 700 how to tell if it has updated kit or not
    By Mc343 in forum Polaris Open Discussion
    Replies: 8
    Last Post: 02-06-2017, 11:52 AM
  2. 95 SL750 how to tell if its pumping water?
    By jsnyder11 in forum Polaris PWC Performance
    Replies: 1
    Last Post: 08-28-2013, 03:49 PM
  3. How to tell if you ski is too looose on the water?
    By 2fast4u in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 10-22-2006, 07:23 AM
  4. How to tell if you have 06 clutch shaft?
    By Water4fire in forum 4-Tec Performance
    Replies: 1
    Last Post: 08-25-2006, 09:22 PM
  5. How to tell if you need a new wear ring?
    By NateGP1300R in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 06-05-2006, 12:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •