Thread: 7800 rpms????
05-27-2007, 02:53 PM #1
Question for you guys, I'm new to the forum so i apologize if this has been awnsered before..... I have 05 RXP Riva Stg 1 , opas deletion, rear exit exhaust, BOV, Vts Extention Rod, Riva 06 clutch washers w/ upgraded shaft and a nice new tight wear ring. I have adjusted my throttle cabe so its right based on hulks tip of the day and im still only seeing between 7800 and 7900 rms on glassy water? Any Ideas what my issue may be? My buddy just bought a new RXP and im pulling from him buy a mile an hour or 2 but dosent seem to pull as I thought it should. Any suggestions?
05-27-2007, 02:54 PM #2
Do you have a boost gauge? You might have a boost leak somewhere.
05-27-2007, 03:55 PM #3
05-27-2007, 03:57 PM #4
05-28-2007, 08:55 PM #5
- Join Date
- Sep 2006
- winchester va
take a mm or 2 out of ur prop
05-29-2007, 08:44 AM #6
so will the new prop be a 14/17 then?
05-29-2007, 07:33 PM #7
Check your riva intake grate and make sure its not lose,mine was losing the same rpms and that was my problem.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By melcraven in forum 4-Tec PerformanceReplies: 3Last Post: 10-19-2009, 05:07 PM
By RMcElarney in forum 4-Tec PerformanceReplies: 12Last Post: 06-19-2007, 11:26 AM
By rxpblast in forum 4-Tec PerformanceReplies: 6Last Post: 06-03-2007, 06:26 AM
By wakeborder556 in forum 4-Tec PerformanceReplies: 4Last Post: 07-17-2006, 10:09 AM
By speeddemon in forum 4-Tec PerformanceReplies: 9Last Post: 06-05-2006, 05:23 PM