05-29-2007, 05:11 PM #1
What's everyone using to replace the SC hose clamps??
I had to remove my superchargers yesterday and was wondering what people were using to replace those Sea Doo clamps. One charger I noticed has already been off by the dealer (don't really know why) and they just replaced it with SS hose clamps. They held up fine for the 2 times I've been out since. The SC has a lip on it so I know it'll hold fine but the TB doesn't. I was thinking some T-Bolt clamps but they maybe hard to find on short notice. Gotta have the chargers back on by Saturday!!!! Thanks for any help.
05-29-2007, 05:21 PM #2
home depot SS worm drive clamps. T-bolt clamps are nice but unnecessary unless running higher boost.
05-29-2007, 05:41 PM #3
T-bolt clamps are easy to find during the week but not so on the weekends; any hydraulic supply store or hose supply store will have them. Try the yellow pages under hose supply store.
I have painted steel t-bolt clamps on my exhaust. I am not worried about steel because if they rust up I will have other problems to worry about than hose clamps.
05-29-2007, 05:52 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By giguchan in forum Open DiscussionReplies: 18Last Post: 06-06-2013, 09:46 PM
By steffi69 in forum Yamaha PWC Performance (4-stroke)Replies: 12Last Post: 05-31-2011, 02:19 PM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 05-27-2011, 05:10 AM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 05-26-2011, 05:04 AM
By KeithKman in forum 4-Tec PerformanceReplies: 16Last Post: 08-02-2010, 09:46 AM