06-04-2007, 04:19 PM #1
Using Rivets to Lock Down Tiny Tach
I am trying to figure out a gun I can use to rivet the tiny tach down. Most are too big. Anyone know of one that will work? The space is so small from the hole to the side of the tach.
06-04-2007, 04:27 PM #2
Check out these guys. I would just be afraid the pressure that would be put on it would crack the plastic. Especially if it is not perfectly flat. Can you use a small nut and self locking bolt?
06-04-2007, 04:37 PM #3
The rivets I have will work. Perfect size, the ones that came in my hydroturf kit. It is the gun that is the problem
06-04-2007, 05:39 PM #4
06-04-2007, 05:41 PM #5
06-05-2007, 01:35 AM #6
- Join Date
- Jul 2006
I used clear silicone and its been holding tight for over a year now. $2 and 1 minute of your time. Its nice because if you want to relocate or remove it there arent any holes left behind. I can pull on it pretty hard and it wont move a bit. If I want to remove it though all it would take is a little prying from a corner and peeling it upward slowly.
06-05-2007, 02:58 PM #7
Just use 3M velcro...DONE! This is how i roll and if ever take the tach off,there will be no holes.
06-05-2007, 03:01 PM #8
06-05-2007, 03:09 PM #9
Let me see if I can post a picture of where I am trying to put mine. My camera is missing and the only thing I have is my Blackjack.
06-05-2007, 03:53 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By alex29573 in forum Yamaha ClassifiedsReplies: 4Last Post: 06-25-2008, 06:20 PM
By Ramps in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 02-09-2008, 02:38 PM
By Rodneyae in forum Polaris Open DiscussionReplies: 12Last Post: 04-30-2007, 10:27 AM
By RXP'in in MI in forum 4-Tec PerformanceReplies: 2Last Post: 10-12-2006, 11:13 AM
By QuickMick in forum Yamaha How To & FAQsReplies: 0Last Post: 05-23-2006, 09:51 PM