Thread: RR IC install tips???
01-24-2006, 11:06 PM #1
RR IC install tips???
Hey guys just so I don't just over load Jerry I'll ask all of ya'll as well.
What is the best way to run the water lines for the RR IC?
I am thinking of just adding hose to both of them and keep them running around the side of the motor on the air intake side and just connecting them straight into the IC.
I just am not sure if to long of a hose is a issue?
I was tring to keep the hose from the pump away from the pipe.
01-24-2006, 11:16 PM #2
austin, black hose with green stripe coming from the pump goes to the left (lower most) fitting on the IC
the other hose can be routed around intake side of engine up around the front where the stock hose came off the stock IC. Just use a 3/4" barbed coupler to attach this hose to the hose going to the front of the exhaust manifold.
01-24-2006, 11:23 PM #3
Yea, I got all that, but the hose comming in from the pump is next to the
power pipe. It actually lays on it. So I was tring to find a better way to do it.
I have already done it the first way and just didn't like the hose lay out.
01-24-2006, 11:25 PM #4
Alright guys never mind Hulkster has put me back on track.
01-24-2006, 11:28 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By thompsdw in forum Sea Doo How To & FAQsReplies: 56Last Post: 05-26-2016, 10:42 PM
By Duke in forum Yamaha How To & FAQsReplies: 51Last Post: 11-19-2015, 07:21 PM
By JFizzleJR in forum 4-Tec PerformanceReplies: 27Last Post: 06-25-2008, 07:12 PM
By MIARider in forum 4-Tec PerformanceReplies: 17Last Post: 12-06-2007, 09:05 AM
By mrbtd in forum Yamaha How To & FAQsReplies: 5Last Post: 05-29-2007, 04:41 PM