06-08-2007, 02:25 PM #1
Installed Riva Free Flow Today...
Just finished installing my Riva Free Flow Kit... All went well - however - no one seemed to mention how much of a PIA tightening the second hose clamp was going to be on the exhaust outlet - OMG! I used a few chioce words while doing that - everything else was a breeze. So, enough of that - I was wondering if you guys thought I should call Kawasaki and thank them for the free tools they left in my hull???? There were 7 unused rivets, 2 zip ties, 12mm socket, 10mm socket, 1 hose clamp and one bolt - not to mention the 43 pounds of excessive silicone everywhere in the hull. Just got everything back together - my dealer just called and said my wedge was in - so I am heading to get it to install it - then I am plugging the ride plate holes and polishing the bottom and hopefully hittin the water in the morning.
Last edited by Ultra Junkie; 06-09-2007 at 12:04 AM.
06-08-2007, 02:37 PM #2
06-08-2007, 02:44 PM #3
Hey Junkie, post your pics!!!
06-08-2007, 03:44 PM #4
Hey EarthShaker - Didn't take any while in the process - it's all back together now and you can barely even see the exhaust tube - sure does sound better - can't wait to hit the water....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By toyterrific in forum Yamaha PWC Performance (2-stroke)Replies: 22Last Post: 02-02-2011, 07:31 PM
By RX951 in forum Yamaha How To & FAQsReplies: 34Last Post: 10-15-2009, 01:37 PM
By inchadeboca in forum Kawasaki PWC Performance (4-stroke)Replies: 5Last Post: 06-28-2008, 09:09 PM
By NeverEndn in forum 4-Tec PerformanceReplies: 2Last Post: 08-03-2006, 10:55 PM
By NateGP1300R in forum Yamaha PWC Performance (2-stroke)Replies: 31Last Post: 06-04-2006, 07:23 PM