Results 1 to 4 of 4
  1. #1
    MPower's Avatar
    Join Date
    May 2005
    Location
    Raleigh, NC
    Posts
    3,338
    +1
    121

    Exclamation Cylinders stuck to the case?

    I'm trying to take the cylinders off. #3 came right off. #2 is stuck on the intake side but off on the exhaust side. #1 is just flat out stuck and wont move an inch. I'm guessing they are stuck to the pins?

    Any ideas? I've never taken the cylinders off before.


  2. #2
    Never say never KirkF350's Avatar
    Join Date
    Jun 2005
    Location
    Midlothian, Texas
    Posts
    4,433
    +1
    3
    Did you try tapping on the cylinder with a rubber mallet? Try and hit it from each side. They can be a little work to get off. Why are you taking it down?

  3. #3
    MPower's Avatar
    Join Date
    May 2005
    Location
    Raleigh, NC
    Posts
    3,338
    +1
    121
    Quote Originally Posted by KirkF350 View Post
    Did you try tapping on the cylinder with a rubber mallet? Try and hit it from each side. They can be a little work to get off. Why are you taking it down?

    I started to use a rubber mallet, but not very hard. I'll try again a little harder.

    Taking it down because I still can't find my problem. I've tried new starter, new starter relay, all ground wires, everything electrical I think.

    Couple forum members say it might be the crank, so im just rippin into it.

    This sucks...

  4. #4
    Never say never KirkF350's Avatar
    Join Date
    Jun 2005
    Location
    Midlothian, Texas
    Posts
    4,433
    +1
    3
    Wack it a little harder. I doubt that you could hurt anything. I usually hit one side, then the opposite side, and so on.
    Damn dude, that does suck.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Methods for removing the coupler from engine to split cases
    By JoeyDFZS in forum Yamaha PWC Performance (4-stroke)
    Replies: 20
    Last Post: 10-17-2014, 08:30 AM
  2. what tools do i need to split the case to chk crank.........?
    By jk0420 in forum Polaris Open Discussion
    Replies: 5
    Last Post: 03-02-2011, 11:34 AM
  3. cheapest place to buy fluid flim cans by the case?
    By official_style in forum Kawasaki PWC Performance (4-stroke)
    Replies: 11
    Last Post: 07-17-2010, 02:38 PM
  4. Is it normal for the cylinders not to be the same size?
    By jpa1300 in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 08-21-2007, 12:21 PM
  5. 46RXP to the GREEN courtesy phone please...........
    By SKR8PN in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 05-28-2005, 07:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •