06-15-2007, 06:12 PM #1
Well the flywheel final came off!
The night I made the last post about the thing not moving and me bending shit I had the puller cranked on hard and it sat like that all night. The next day after work I went to check on it and sure enough, the flywheel and puller were sitting on the floor
From there I started pulling the engine apart and got the engine case split and the crank out. All the bearings feel and look perfect. Zero rust anywhere. No pitting or any other foreign defects. I'm still going to have to trued & welded for ease of mind.
06-15-2007, 06:40 PM #2
06-15-2007, 09:14 PM #3
SantaCruz .Check little end surfaces for lines and pitting and away you go
06-16-2007, 12:06 AM #4
- Join Date
- Aug 2006
Hopefully the flywheel didnt take too long of fall and or too hard of hit on the floor!!
I doubt ya have any problems, but in the future, dont ever let a flywheel drop....it can de-magnitize.
06-16-2007, 12:10 AM #5
- Join Date
- Oct 2006
- Cleveland OH
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo Open DiscussionReplies: 22Last Post: 11-25-2008, 03:31 PM
By Noslo5.0 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 05-01-2007, 08:44 PM
By Altron in forum Polaris Open DiscussionReplies: 2Last Post: 03-13-2007, 08:08 AM
By '02GPRider in forum Open DiscussionReplies: 0Last Post: 10-04-2006, 02:51 PM
By Pettee in forum Sea Doo Open DiscussionReplies: 10Last Post: 03-21-2006, 12:51 PM