Results 1 to 4 of 4
  1. #1

    Join Date
    Aug 2006
    Location
    Iowa
    Posts
    1,028
    +1
    2

    Elec. testing. Anyone done this?

    Just out in the shop trying to figure out my trim malfunction.

    Power to the bilge and trim system is delivered from the LR module while running.

    I'm positive my method on mind of testing will work just fine, but anyone done this...

    Unhook the LR module wire (orange) from the circuit board. Take a jumper lead from Red/purple to the circuit board to power it (as simulating the engine is running)

    I'm pretty sure it shouldnt cause me any problems.?


  2. #2

    Join Date
    Aug 2006
    Location
    Iowa
    Posts
    1,028
    +1
    2
    OK, so I was wrong.....Popped my 1/4amp doin it

    I was in just too big of hurry! Once I looked it over again and re-thought the wiring I figured it out.

    Switch is working....
    Leads to trim motor working as well as motor....
    Switch to board is working....

    At this point, I unhooked my Grn/White and Blu/W that go to the MFD. Unhooked my Switch ground and switch power (orange)

    Powered those leads and switch and all works as supposed to.

    I either I had a wiring harness connection problem, or my LR module is going south.

    If anyone ever needs help doing these tests.....gimme a shout.

    Now for the real fun of finding the AGC 1/4 amp tomorrow

  3. #3
    She likes the bike. But the ski gets her wet!!!! xlint89's Avatar
    Join Date
    Oct 2006
    Location
    Cleveland OH
    Posts
    17,330
    +1
    31
    Radio Shack, I've been told.

  4. #4

    Join Date
    Aug 2006
    Location
    Iowa
    Posts
    1,028
    +1
    2
    Yeah, Just checked a small Radio Shack on my way home from work today. The lowest they went was 1/2 So I'm gonna stop at a bigger one tomorrow and stock up on them if they got them. It seems that everytime I've needed one of these fuses I'm in a rush

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help...swapping hulls. GTX to RXP anyone done this?
    By b_dolla44 in forum 4-Tec Performance
    Replies: 43
    Last Post: 01-04-2011, 05:08 PM
  2. Replies: 12
    Last Post: 11-03-2010, 12:07 AM
  3. Has anyone done this?
    By outonalimb in forum Sea Doo Open Discussion
    Replies: 6
    Last Post: 06-29-2010, 09:31 AM
  4. Anyone done this....?
    By GeoRXT in forum Sea Doo Open Discussion
    Replies: 7
    Last Post: 09-01-2006, 01:25 PM
  5. Anyone done this??
    By DeeGee in forum 4-Tec Performance
    Replies: 5
    Last Post: 07-12-2006, 05:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •