Thread: Driveshaft removal SL 750
06-27-2007, 10:22 PM #1
- Join Date
- Jun 2007
- Little Elm, TX
Driveshaft removal SL 750
I must not be using the right search terms, couldn't find the answer.
I got the pump off but the shaft is still attached to the engine. Should it just pull out or is it secured in there some how?
06-27-2007, 10:41 PM #2
if you pulled the pump it will slide out there is a rubber seal on the cranck adapter that holds it in there must pull real hard if it hasent been greased somtimes the metal from wear holds it in there also
06-27-2007, 10:41 PM #3
Just give her a pull, the seal at the coupler is nice and tight.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By KeithKman in forum 4-Tec PerformanceReplies: 22Last Post: 07-31-2010, 05:34 PM
By tdloose in forum Polaris Open DiscussionReplies: 1Last Post: 08-13-2009, 03:48 PM
By STSPERFORMANCE in forum Sea Doo Open DiscussionReplies: 27Last Post: 01-22-2009, 08:05 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 16Last Post: 10-18-2007, 08:32 AM
By INDY27 in forum 4-Tec PerformanceReplies: 34Last Post: 09-21-2006, 07:46 PM