Results 1 to 4 of 4

Thread: head mill???

  1. #1
    PAINKILLER's Avatar
    Join Date
    Jul 2005
    Location
    Marion, Ohio
    Posts
    277

    head mill???

    how much do you have taken off the milled heads? and whats the limit on how much you can go?


  2. #2
    Moderator
    I build Horsepower
    NitroShark's Avatar
    Join Date
    Jan 2006
    Location
    Greenville,SC
    Posts
    1,372
    +1
    9
    you should CC the head (and piston domes) first, then calculate the Cr-ratio.

    You will know what you have, and were your going.

  3. #3
    PAINKILLER's Avatar
    Join Date
    Jul 2005
    Location
    Marion, Ohio
    Posts
    277
    if i was bill nie the sience guy that might help
    can you break that down in easier to understand terms? thanks

    does the Cr-ratio have to do with pie 3.1444444444?

  4. #4
    Moderator
    I build Horsepower
    NitroShark's Avatar
    Join Date
    Jan 2006
    Location
    Greenville,SC
    Posts
    1,372
    +1
    9

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. head milling
    By johnboygtv in forum 2-Stroke Performance
    Replies: 3
    Last Post: 08-29-2009, 03:41 AM
  2. stock head milling
    By 2004 xlt1200 in forum Yamaha PWC Performance (2-stroke)
    Replies: 8
    Last Post: 07-03-2009, 10:20 AM
  3. stock head milling ?
    By steven1300r in forum Yamaha Open Discussion
    Replies: 31
    Last Post: 12-17-2008, 09:23 PM
  4. OEM head milling compression results
    By night022 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 09-18-2008, 07:00 PM
  5. stock 951 head milling? how much?
    By 1fastrat in forum 2-Stroke Performance
    Replies: 12
    Last Post: 08-26-2008, 07:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •