Results 1 to 7 of 7
  1. #1
    MRO's Avatar
    Join Date
    Jan 2007
    Location
    Michigan
    Posts
    124

    Supercharger Gasket Material?

    Hi all,

    I just received my (2) Green supercharger impellers (Thanks Jerry! The wheels look awesome!) but upon reinstalling the two housing halves, I cannot find the recommended Lock tite 5910 that the service manual recommends using anywhere around locally.

    My question is can you just use Permatex ultra black high temp silicon on the two halves? Or is there any other gasket sealer out there that would be an adequate substitute?

    Any help would be appreciated. I'd like to test these wheels out this Saturday and give my results.

    -Matt


  2. #2
    Fast & Loud meeper's Avatar
    Join Date
    Jul 2005
    Location
    West Grove, PA
    Posts
    5,019
    +1
    54
    i used permatex gray, holds up to more heat

  3. #3
    lugnut's Avatar
    Join Date
    Jul 2006
    Location
    Texas
    Posts
    233
    Same here..no issues

  4. #4
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Location
    Morgan City, LA
    Posts
    36,398
    +1
    2,524
    Permatex Ultra Black is what i use.

  5. #5
    MRO's Avatar
    Join Date
    Jan 2007
    Location
    Michigan
    Posts
    124
    Great! Thanks all!!!

    -Matt

  6. #6
    GTXX's Avatar
    Join Date
    Jan 2006
    Location
    NW, GA
    Posts
    1,776
    the stuff sea-doo calls for is a low viscosity silicone like is used on case halves of a two-stroke. It's much thinner than the Ultra Black, but if everyone says the the Ultra works OK...

  7. #7
    suck my wake's Avatar
    Join Date
    Apr 2006
    Location
    Sugar Grove IL
    Posts
    2,872
    +1
    12
    The ultra black has been workin fine for me

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for gasket material
    By Mudbone in forum 4-Tec Performance
    Replies: 3
    Last Post: 08-01-2013, 03:27 PM
  2. Gasket material question
    By MatthewZ in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 07-04-2013, 09:36 PM
  3. Which gasket material?????
    By MatthewZ in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 04-27-2013, 10:00 PM
  4. Making your own gaskets- using cork-rubber gasket material
    By Bres05 in forum Polaris Open Discussion
    Replies: 8
    Last Post: 08-21-2012, 12:01 AM
  5. any thoughts on removing silicone gasket material
    By rosey in forum Yamaha PWC Performance (4-stroke)
    Replies: 4
    Last Post: 07-11-2012, 01:34 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •