Thread: R&D Intake grate
07-08-2007, 10:34 PM #1
R&D Intake grate
So I was out today and was playing around next thing you know I suck up a ski rope. Luckily no damge was done I noticed it right when I went on top and killed it, but being at the end of the day I just took it home and removed it and all was good but
While I was at it I was going to put on my new R&D I got from Art a couple weeks back but I run into a problem trying to get it off. Any socket I use does not sit al the way on the head of the bolt as it is recessed in a bit. Now inside the hull the other side I cant see but it fills round and has some sort of notch or something but it spins as I spin the head of the bolt when I can.
Is there a special tool or socket or a secret to removeing the intake grate?
07-08-2007, 10:43 PM #2
Ron, you just need a thin wall socket to get at the bolt out at the intake grate..
07-08-2007, 10:54 PM #3
- Join Date
- Aug 2006
Odd, mine has a #3 phillips bevel-head.
07-08-2007, 10:57 PM #4
I've seen averything from phillips, to allens to safety stars.
07-09-2007, 08:53 PM #5
Thanks for the replies. Mine is a 12mm but i just cant get enough grip to get it off. Ill run to local hardware store and grab a set of thin wall sockets.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kenshin89 in forum 4-Tec PerformanceReplies: 11Last Post: 03-17-2007, 02:09 PM
By Jeff C in forum 4-Tec PerformanceReplies: 10Last Post: 08-15-2005, 01:32 AM
By 01xdime in forum 4-Tec PerformanceReplies: 8Last Post: 08-12-2005, 09:10 AM
By Krazy-K in forum 4-Tec PerformanceReplies: 1Last Post: 07-12-2005, 09:43 PM
By SUPERBEAST in forum 4-Tec PerformanceReplies: 14Last Post: 06-05-2005, 12:57 AM