03-06-2006, 08:08 PM #1
Good info on plugging rideplate holes
Took this off the Yamaha forum.
03-06-2006, 08:32 PM #2
03-06-2006, 09:09 PM #3
great info there....i will be doing this over the summer!
03-06-2006, 11:49 PM #4
great info thanks i should look into doing this looks simple enough.
so aqua mend is good enough?
03-07-2006, 11:07 AM #5
That would be a good sticky in technical information for
How to plug ride holes. The rope thing is a great idea. I used 5 minute epoxy with the tape trick my first time and it came out on the RXT. Then I went to JB weld and it hasn't left yet.
I hope the Riva rideplate mod doesn't use those bolts
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 71Last Post: 08-12-2012, 07:06 PM
By boataddict in forum 4-Tec PerformanceReplies: 51Last Post: 03-12-2010, 08:46 PM
By sr71bb in forum 4-Tec PerformanceReplies: 4Last Post: 08-02-2006, 08:01 AM
By 05rxt in forum 4-Tec PerformanceReplies: 17Last Post: 07-04-2005, 04:14 PM
By two2curupt in forum 4-Tec PerformanceReplies: 4Last Post: 05-21-2005, 04:01 PM