Thread: holes in ride plate
07-26-2007, 08:57 PM #1
holes in ride plate
i am geussing those holes you are talking about are the ones that hold the ride plate on. can i use silicone and putty them smooth what should i expect.
07-26-2007, 09:25 PM #2
Silicone wont stay in the holes. Most use epoxy but cover the bolt heads first with duct tape to keep the epoxy off them. you could expect .5 mph or more.
07-26-2007, 09:42 PM #3
I used JB weld in the stick.... I did not do the duct tape thingy but on the yami I just used a hammer & screw driver and got it all cleaned out.
07-27-2007, 11:05 AM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rhorne1053 in forum Kawasaki PWC Performance (4-stroke)Replies: 12Last Post: 02-15-2007, 11:15 PM
By mjammer in forum 4-Tec PerformanceReplies: 26Last Post: 05-12-2006, 05:53 AM
By somefun in forum 4-Tec PerformanceReplies: 5Last Post: 05-07-2006, 11:24 PM
By Lurker in forum 4-Tec PerformanceReplies: 0Last Post: 02-25-2006, 07:33 PM
By JRW1484 in forum 4-Tec PerformanceReplies: 2Last Post: 02-20-2006, 09:35 PM