Results 1 to 6 of 6
  1. #1

    oil pump block off

    Whats the best way to block off the pump?


  2. #2
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,929
    +1
    1,407
    Pull the pump, Remove the gear and spacer, Make or buy a plate, seal the plate to the case. Cap off the oil feed nipples I like to solder them shut. Install 33 OHM resister across where the oil sender wires are in the e-box. Or hose clamp the float to the top if you leave the tank. I like to leave the tank just to have oil on-board for the gas dock if needed. I put a spigot on the outlet and marked off Oz's on the side of the tank.

  3. #3
    I heard that you can turn the the gear down an put it back in. Would that be better or just leave it out.

  4. #4
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,929
    +1
    1,407
    Just leave it out. Stuffing the cases on a rec ski will not matter.

  5. #5
    Ok, that makes it easyer. thanks

  6. #6
    Tony's Avatar
    Join Date
    May 2007
    Location
    North Carolina
    Posts
    1,760
    +1
    38
    I pulled the gear and reinstalled the pump, plugged the ends of the lines with silicone and put them back on carbs. I bought a WSM fuel selector w/reserve and converted the oil tank into my reserve tank.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Oil Pump Block-off Kit
    By polaris24 in forum Polaris Open Discussion
    Replies: 6
    Last Post: 06-11-2008, 10:09 PM
  2. Putting oil pump block off plate on
    By mboley in forum Polaris Open Discussion
    Replies: 2
    Last Post: 04-19-2007, 11:37 AM
  3. Oil pump block-off for 951
    By seadoo951 in forum 2-Stroke Performance
    Replies: 12
    Last Post: 03-01-2007, 04:11 PM
  4. Fuji oil pump block off
    By ph2ocraft in forum Polaris PWC Performance
    Replies: 8
    Last Post: 09-21-2006, 06:32 PM
  5. Question? Oil pump block off.
    By great lakes gpr 1200 in forum Yamaha How To & FAQs
    Replies: 3
    Last Post: 03-26-2006, 01:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •