Results 1 to 2 of 2
  1. #1
    Chine Walker
    Join Date
    Nov 2006
    Posts
    598

    Do you need to prime oil pump if ur warning beep goes off?

    I was out riding today and after going over some rough water my oil level buzzer went off. Once I went to calm waters the oil icon on the panel went out. I headed back to the ramp and on my way, I did a few tight turns playing around. The buzzer went off again and as I rode back in,the icon went out. During the flush on the trailor the buzzer didn't go off.
    What I'd like to know is do I need to prime the pump because of the low oil level; could I have sucked air into the system?
    Thanks in advance,

    jp

    2003 GPR w/oil injection


  2. #2
    Pm sent.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. what do you need to do to run Seadoo pump w/ VTS on conversion
    By HallPass in forum Conversion FAQ and Tips
    Replies: 2
    Last Post: 05-30-2010, 12:09 AM
  2. Do I need to remove oil pump to run premix?
    By ucf_motorcycle in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 07-19-2009, 07:26 PM
  3. Question: do you need to remove impeller to replace wear ring?
    By djames59 in forum Sea Doo Open Discussion
    Replies: 5
    Last Post: 06-11-2009, 10:31 AM
  4. What do you need to go from stg3 to turbo?
    By ski-guy1 in forum 4-Tec Performance
    Replies: 5
    Last Post: 05-11-2008, 07:39 PM
  5. what do you need to do to install a cam
    By breon in forum 4-Tec Performance
    Replies: 23
    Last Post: 12-25-2007, 02:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •