Thread: Water intake washer question
08-12-2007, 08:10 PM #1
- Join Date
- Jun 2005
- Hamilton, Ontario, Canada
Water intake washer question
When you remove the pump you notice a washer incased in a yellow rubber gasket. At least that is the colour on an 04. It actually resides within the pump support but always sticks to the pump when you remove it. See the pic below.
My question is why is the inner diameter of this washer so small, and why not remove the washer so that it is the same diameter as the water intake tube? Or is this restricted on purpose to control the amount of water/flow going into the IC? Would this be worth removing or more specifically replaced with a washer that has a wider inner diameter for anaftermarket IC. Not sure if it would result inmore efficient flow or not but just a thought.
08-12-2007, 08:35 PM #2
Being from jettboat guruness (if so), always remeber,,,A PUMP OVER WATERS A MOTOR!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lee in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-10-2007, 09:47 AM
By mysilvstang in forum 4-Tec PerformanceReplies: 4Last Post: 12-31-2006, 10:07 AM
By The Bandit in forum 4-Tec PerformanceReplies: 2Last Post: 07-31-2006, 07:15 PM
By Alex13 in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-24-2006, 03:57 PM
By rossnemo in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 07-20-2006, 01:17 PM