08-14-2007, 04:25 PM #1
How to get Pump Shoe inserts out??
What is the Best/fastest way to get them out, and get all the Goop out?
08-14-2007, 04:30 PM #2
* I've done 3 skis like this, and it works everytime. The last ski I did was Jetskr's 03 GPR.
* Removing the rear stinger helps too in giving more room.
some people use a heat gun, but I don't like the fumes.
08-14-2007, 04:36 PM #3
I had yami put in the upgraded brackets, do you think that will be an issue, as far as screwdriver prying?
08-14-2007, 04:39 PM #4
08-14-2007, 04:42 PM #5
08-14-2007, 04:44 PM #6
here is a pic but not great.. you can also see the stuff they used on the black hose in the pic
08-14-2007, 04:47 PM #7
Yeah James, you'll have to use a die grinder to grind it all out. Repair the areas well with marinetex before doing the tunnel reinforcing process.
08-14-2007, 07:56 PM #8
well, so far so good!! Got a PM to torch it, then used your "billy" screw driver to pry it up trick, and walla
I got about 90% out and the hole in the side actually looks worse. looks like it fallows that slanted line all the way to the bottom...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By oz_speed in forum 4-Tec PerformanceReplies: 8Last Post: 08-15-2011, 09:56 AM
By Jetscreamer in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 05-11-2007, 10:06 PM
By H204YOU in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 07-22-2006, 09:09 PM
By Shibby1485 in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-18-2006, 09:31 PM
By spud in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 01-12-2006, 12:28 AM