08-25-2007, 05:31 PM #1
Ive only used my new RXT a couple times. Im always using it in saltwater, so I always flush it. The manual says to flush at a "high idle" 4000-5000 rpm for 20 seconds. I turn the ski on, then the water. When its just idling it sounds fine, but once I rev it to around 4000, it starts making a really ugly, raspy sound. It sounds like im hurting it, so im hesitant to keep it there for long. But the manual says to? Im just wondering if it would be adequate to just let it idle for a couple minutes.....
08-25-2007, 07:45 PM #2
Yeah it tends to make like somethings is loose. have no fears.
I flush mine running idel for a minute or 2.
After I shut off the water I give it a quick throttle up. Then shut it down.
08-25-2007, 08:43 PM #3
Also, since you are running in salt water like me check out threads about 'Salt
Away'. You use it to flush the ski and leave it in the ski to neutralize any salt in the intercooler, manifold and exhaust. Good stuff.
08-25-2007, 08:50 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 32Last Post: 08-04-2011, 04:11 PM
By 1FastTrespiper in forum Sea Doo How To & FAQsReplies: 8Last Post: 10-29-2007, 01:33 PM
By Ed in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-25-2005, 04:42 PM
By Red Devil in forum 4-Tec PerformanceReplies: 3Last Post: 05-12-2005, 09:11 PM
By Vern in forum Sea Doo Open DiscussionReplies: 5Last Post: 05-11-2005, 01:36 AM