Thread: stator ohms ???
08-26-2007, 10:10 AM #1
stator ohms ???
Ok,I need some help on getting a voltage meter test on my stator to see if it is going bad or not,needed to know what ohms it should have when crossing from wire to wire.
08-26-2007, 10:57 AM #2
I dont have the manual here at home but if you have .4 ohm - .8 ohm on all three legs and no continuity to ground on any of them you should be just fine. A running ac voltage test would be even better. Test for ac voltage while reving up on a flush kit. It only takes a second to get a reading. Should be at least 50 volts ac on each leg. You still need to make sure that you dont have continuity to ground on any of the 3 legs even if it has the ac voltage.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mrjetskey in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 05-20-2013, 09:50 AM
By Carguybri in forum Polaris Open DiscussionReplies: 3Last Post: 07-27-2012, 09:11 PM
By fosterz in forum Polaris Open DiscussionReplies: 14Last Post: 06-25-2012, 06:23 PM
By hydrojunkie in forum 4-Tec PerformanceReplies: 5Last Post: 04-03-2011, 08:37 PM
By vomitspot in forum 2-Stroke PerformanceReplies: 4Last Post: 05-05-2009, 07:46 PM