Results 1 to 3 of 3
  1. #1

    can't get my wear ring out!!!!

    i got a 03 gtx with the composite pump. tryed the freezer method that didnt work, even tryed putting it in the sink and pouring hot water on the housing area to try to expand it that didnt work. and i did remove the 2 screws that hold the ring in place.


  2. #2
    nevermind!! i just found the other 2 screws hiding under the venturie tubes.. damn thing fell out after that!!

  3. #3
    Quote Originally Posted by FL03GTX View Post
    nevermind!! i just found the other 2 screws hiding under the venturie tubes.. damn thing fell out after that!!
    there ya go! I was just about to say did ya look under the???...PR...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How can I get my MSX110 out of limp mode?
    By andyne in forum MSX/Matrix
    Replies: 3
    Last Post: 06-06-2014, 11:04 PM
  2. How do you get wear ring out of plactic pump
    By 111toybox in forum 4-Tec Performance
    Replies: 5
    Last Post: 08-06-2012, 07:14 PM
  3. Replies: 3
    Last Post: 04-17-2009, 05:31 PM
  4. 60.9 Mph on my RXT BLAHHH!! Can it be my Wear ring?
    By Sosa62 in forum Sea Doo Open Discussion
    Replies: 25
    Last Post: 07-31-2007, 10:49 AM
  5. How do you get stainless wear ring out?
    By Pale Rider in forum 4-Tec Performance
    Replies: 9
    Last Post: 04-29-2007, 03:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •