Thread: Ceramic bearing failures?
08-27-2007, 06:20 AM #1
Ceramic bearing failures?
How many out there haver had the ceramic bearings fail on them?
08-27-2007, 10:52 AM #2
08-27-2007, 10:54 AM #3
I have heard of 4 or 5 sets failing (two of which are mentioned above)
I told the manufacturer about the failures and he flipped out saying any failures are not acceptable and he started shipping me bearings with even stronger cages that are titanium fiber reinforced. He promised me nobody would break these so we'll see.
08-27-2007, 07:42 PM #4
08-27-2007, 08:14 PM #5
- Join Date
- Jul 2006
are those the new ceramic bearings?
08-27-2007, 08:45 PM #6
Jerry has any of the ceramics bearings you install failed like this, or just the ones who used the BFH method?
08-27-2007, 08:46 PM #7
08-27-2007, 08:58 PM #8
Now, I had some water get sucked in through the SC one day & I ran the schit out of it immediately after the water was removed.. 6 hrs since then this happened. I posted about the incident last week & was told to run it. Anyway, you think the bearings were the cause of my barely above 8psi of boost from day one with my setup. Boost was measured by 2 different guages & read the same.
08-27-2007, 09:05 PM #9
08-27-2007, 09:06 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Fateracing in forum 4-Tec PerformanceReplies: 18Last Post: 09-25-2007, 06:59 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 51Last Post: 07-13-2007, 12:13 PM
By yellow jacket in forum 4-Tec PerformanceReplies: 73Last Post: 07-02-2007, 03:42 PM
By Jarrett in forum 4-Tec PerformanceReplies: 17Last Post: 11-08-2005, 08:59 PM
By Jarrett in forum 4-Tec PerformanceReplies: 5Last Post: 07-14-2005, 07:35 AM