Thread: what wires for vts gauge on rxt
09-01-2007, 01:15 PM #1
what wires for vts gauge on rxt
in the process of puting trim on my rxt. i need to know what wires to use to get the gauge to work on the cluster. when you power the ski up the gauge comes on, so it must have the wires some where to be used. thanks
09-01-2007, 01:35 PM #2
The VTS switch has 3 wires.
The blue/white wire controls UP
The green/white wire controls DOWN
The black wire is a ground.
The blue/white & green/white from the switch connect to the same colored wires coming from the VTS motor.
The black wire goes to ground.
You also have a connector coming from the VTS motor with a red and black wire. The black wire goes to ground. The red wire goes to (+) constant on. You will want to fuse this red wire with a 7.5 amp fuse.
There is a purple wire that comes from the VTS motor. This wire will be connected to (+) source which is switched on/off with the lanyard.
This leaves 2 remaining wires coming from the VTS motor. A brown wire and a brown/striped wire. These are for the gauge.
You can manually wire the brown wires to an old XPL type gauge. To make it work on the stock gauge cluster i have no idea where to connect them plus the feauture would have to be turned on with the BUDS computer at a dealer.
09-01-2007, 01:59 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By scubasteve in forum 4-Tec PerformanceReplies: 3Last Post: 03-29-2013, 03:25 PM
By aruba yamaha in forum 2-Stroke PerformanceReplies: 3Last Post: 09-28-2012, 06:17 AM
By bruinsrme in forum 4-Tec PerformanceReplies: 3Last Post: 09-03-2007, 03:25 PM
By havoc in forum 4-Tec PerformanceReplies: 11Last Post: 07-15-2007, 12:43 PM
By excess in forum 4-Tec PerformanceReplies: 5Last Post: 06-30-2006, 06:10 PM