Thread: R&D Cool Air Intake Question
09-02-2007, 09:33 PM #1
R&D Cool Air Intake Question
While I'm waiting for the other parts from R&D, I started to put in the cool air intake tonight. Has anyone installed the filter that replaces the block off plate under the glove box? I'm trying to install the filter without taking everything off. I took the two rear bolts off that hold down the glove box and loosened all of the others, but I can't raise the glove box high enough to slide the filter in.
Just wondering if anyone has found a short cut before I start taking more things off.
09-02-2007, 09:36 PM #2
I know 2 people that have done it, everything has to come off
09-02-2007, 09:40 PM #3
09-02-2007, 09:52 PM #4
09-02-2007, 10:00 PM #5
Becareful of water ingestion on the pro series!
09-02-2007, 10:24 PM #6
09-03-2007, 07:40 AM #7
- Join Date
- May 2007
I took mines off completely off saturday. I only removed the left side of the fender (the one with the reverse on it) three screws, remove the gass cap then take off the three screws that hold the left side of the compartment. lift sideways and remove cap. it sounds alot louder. I tryed yesterday on the fl. keys water was flat. make shure no water goes over the hull.
09-03-2007, 08:47 AM #8
Thanks for the help - I only had to take off one fender. I thought taking off the fender on this would be as bad as my GPR (easy to bend or break the plastic clips). The Kawi fender comes right off - much easier.
Now for a little testing...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Diablo in forum Kawasaki PWC Performance (4-stroke)Replies: 11Last Post: 10-01-2007, 04:11 PM
By VaRedneck in forum 4-Tec PerformanceReplies: 3Last Post: 05-29-2007, 05:18 AM
By North49 in forum 4-Tec PerformanceReplies: 6Last Post: 09-11-2006, 09:44 PM
By rxpblast in forum 4-Tec PerformanceReplies: 6Last Post: 11-23-2005, 04:33 PM
By SKR8PN in forum 4-Tec PerformanceReplies: 2Last Post: 06-24-2005, 05:21 PM