Thread: pump seperation
09-04-2007, 09:22 AM #1
ok its a little bit more complicated i bought a "lot" of parts from a board member and im a little dissapointed in the pump..... the wear ring and rear piece are siliconed together.... seperator tabs broken off and the impellar wont turn at all, nothing !!!! how do i get this apart or do i throw it out?
09-04-2007, 12:35 PM #2
Doesn't sound to good. Can you tell if the liner is touching the prop? If this is the case the liner has corrosion between the case and the SS wear ring.
If all the tabs are broken its going to be difficult to get appart. If you can bolt it in a boat it possible a slide hammer might break it apart. Try and find a substantial piece of the pump to grab on to.
09-07-2007, 10:39 AM #3
unbolt the pump, and tap a flat head bit in between the (nozzle/pump)(pump/spacer)...then get a ratchet on the bit and twist, if you do this on both sides softly it should seperate without needing the tabs.
09-07-2007, 11:34 AM #4
- Join Date
- Jul 2006
- Sacramento, California, United States
rdh, good info dude......
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 14Last Post: 08-27-2014, 10:04 AM
By nitro rxp in forum 4-Tec PerformanceReplies: 6Last Post: 06-04-2005, 09:00 PM
By peteshauling in forum 4-Tec PerformanceReplies: 20Last Post: 06-01-2005, 10:08 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 34Last Post: 05-12-2005, 08:56 PM
By RXPNJ in forum 4-Tec PerformanceReplies: 8Last Post: 05-10-2005, 09:47 AM