Results 1 to 2 of 2
  1. #1
    pro12,txi,msx140 SMOKEWAGON's Avatar
    Join Date
    May 2007
    North Carolina

    pro 1200 cdi jumper wire ?

    I seem to having the symptoms described in the service bulletin pwc-00-05. Need to add jumper to cdi box red/purple wire.

    Has anybody actually done this? I guess you just made your own wire?
    Following the wiring diagram and looking at it physically it doesn't make much sense. What happens if you get it wrong?

    What should I do with the extra washer bouncing around in there that some assembly worker left? And should I leave the wire pinched under the ground wire bolt when it was tightened pinching the insulation?
    Were these assembled here or east germany?


  2. #2
    ph2ocraft's Avatar
    Join Date
    Apr 2006
    Campbell, Ca.

    Just run an extension wire from the red/purple going to the CDI over to the orange spade on the board.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. WTB 2001 Pro 1200 CDI
    By Mr. Matrix in forum Polaris Classifieds
    Replies: 31
    Last Post: 10-02-2011, 08:25 PM
  2. Polaris CDI Jumper Wire TSB
    By SeaLion in forum Polaris How To & FAQs
    Replies: 9
    Last Post: 08-30-2010, 01:18 PM
  3. 1999 Polaris genesis CDI jumper wire fix
    By boilerman in forum Polaris Open Discussion
    Replies: 3
    Last Post: 06-20-2010, 06:21 PM
  4. polaris slx 1200 cdi gray wire
    By chandlerwelding in forum Polaris Open Discussion
    Replies: 3
    Last Post: 05-22-2010, 01:24 PM
  5. Wtb Pro 1200 Cdi
    By rgard32 in forum Polaris Classifieds
    Replies: 5
    Last Post: 05-04-2008, 11:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts