Results 1 to 3 of 3
  1. #1
    jetskibum1's Avatar
    Join Date
    Jun 2007
    Location
    Tairua New Zealand
    Posts
    496
    +1
    11

    EGT Temps on 4 Tec engine????

    Is anyone running exhaust gas temp probes on a 215 engine. I am about to install them on my RXP in the holes provided in the Rad 4 Racing torque plate but wonder what temps are the norm.
    I am interested in temps from any state of tune but it would be helpfull to know what mods your running if your quoting temps. A stock base line would be good too.
    Cheers for the help.

    skimd.co.nz


  2. #2
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Location
    Morgan City, LA
    Posts
    36,398
    +1
    2,524
    I run aroun 1400 degrees at WOT (8800 RPM's)
    I tune each cylinder to keep the temps within 75 degrees of each other.

  3. #3
    jetskibum1's Avatar
    Join Date
    Jun 2007
    Location
    Tairua New Zealand
    Posts
    496
    +1
    11

    individual tune

    Cheers Jerry, I am running fixed fueling ecu so only way to adj is across the board with the rising rate reg, ie adj the base presure. I am keen to know of any one running within the 8150 limit to get a base.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. anybody used a EGT- exhaust gas temperture sensor on a fuji engine?
    By andy95'slx780 in forum Polaris Open Discussion
    Replies: 2
    Last Post: 11-01-2010, 12:48 PM
  2. Rev Limit On 4-TEC Non-S/C Engine?
    By spd5535 in forum 4-Tec Performance
    Replies: 3
    Last Post: 04-30-2008, 11:31 AM
  3. How to get my EIN (engine VIN) on 4-Tec?
    By dgiles in forum 4-Tec Performance
    Replies: 3
    Last Post: 04-10-2008, 02:04 AM
  4. Anybody Use The K&N Oil Filters On Their 4-Tec Engine?
    By holdnon72 in forum 4-Tec Performance
    Replies: 32
    Last Post: 04-20-2007, 09:37 PM
  5. Compression on 4-Tec Supercharged Engine
    By ramnj in forum 4-Tec Performance
    Replies: 5
    Last Post: 04-22-2006, 08:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •