Thread: throt conversion kit
09-15-2007, 05:59 PM #1
throt conversion kit
how was it installing the throttle conversion kit, to people that have done it. did you have to tightin the adjustable tensioner that is right before the throttle? or look into the throttle body when adjustting??
anyone have pictures of theirs?
09-15-2007, 06:09 PM #2
the tension will need to be adjusted. Make sure you use the recommended lock tite. Mine came loose.
The Riva kit requires drilling a hole in the handlebars. Not sure if you ever tried to drill a hole in a round piece of stock upside down. Highly recommend using a punch to put a divet in the bars. The divet provides a hole for the drill bit to fit into, instead of dancing all over the place. The drill bit provided in the kit is great for drilling holes in butter that is at room temp. I drilled a small piolt hole and then used the right size bit.
The whole install took about 45 minutes
drill and a decent set of drill bits
pliers or needle nose (4 to 6 inch)
metric allen set
screw driver phillips
and whatever else is recommended on the instructions.
Last edited by bruinsrme; 09-15-2007 at 06:17 PM.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By XRIDER in forum Sea Doo ClassifiedsReplies: 2Last Post: 10-27-2009, 01:41 PM
By need4pwr in forum Yamaha ClassifiedsReplies: 6Last Post: 08-14-2008, 08:30 AM
By motora33 in forum Sea Doo Open DiscussionReplies: 0Last Post: 04-26-2007, 08:34 AM
By Hydrotoys in forum Yamaha PWC Performance (2-stroke)Replies: 16Last Post: 03-05-2007, 09:37 PM
By rlara in forum 4-Tec PerformanceReplies: 14Last Post: 10-07-2005, 05:48 PM